Discussion Locked

No Sound-No cdrom/packard bell 486/33

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

This computer has only 8mb mem,runs really slow,&loads slow.Lost all sound and cdrom reading.Cdrom plugged to sound card & is mitsumi cd rom.Comes up with invalid media win trying to read cd.checked all connections & all seems to be right,it is a packard ?!#@,486/33.Formmatted hard drive using another Pkbell computer to read cd and used master restore disk it came with,huh,to no avail.And yes I fdsked & reformatted and put back in other pkbell computer but same problem.It will not let me updateto Win98 while attached to other computer so I can read CD-rom install disk win 98.Honestly I'm tired of messing with it but I have 4 computers And I like the challenge any help would be appreciated.
Smitty

9 replies

by lord ago 1

The invalid media type happens when a drive isn't setup properly. In this case, it's your CD-ROM drive.
After you formmated and/or fdisked, you have to use a bootdisk that has the CD drivers setup already and has the mscdex.exe . Normally the Rescue BootDisk that comes with the computer is what you have to use on that particular computer setup. Boot from that diskette and try to run the Restore. From there, you should be able to use the CD-ROM drive and the sound card again after you have rebooted your system after the Restore process is complete.
As for updating to Win98, on a 486/33MHz system with 8MB of RAM, that's a rather bad idea. It is supposed to be able to run on that hardware but it will run sooooo horrible that you wouldn't want to bother doing the upgrade to begin with.

Have Fun!!!

by vertex

You'll never ever load Win98 on a 33MHz PC. Win 98 requires a min. of 32MB RAM, Pentium 166 with at least 1 GB of hard disk space to play around with. It will be a real challenge to fit an elephant into roadster!

I am working on a Pentium 133 Mhzwith 32 MB RAM and 1.3GB HDD. My attempt to load Win98 fails and I revert back to the original Win95. I have the same problem of missing Cd-ROM drive. The BIOS can't even detect the CD-ROM at boot-up, my attempt to flash the BIOS is a waste of time since I can't locate the manufacturer. Using Win95 boot disk with CD-ROM support, I managed to get the CD-ROM working and installed the OS. Upon the first boot-up, set-up will prompt me for some other drivers on Win95 Cd, pointing to the Cd-ROM path,I discovered that the system cannot detect the Cd-ROM drive.I Let the system boot-up to the final stage and the D drive show up at Explorer. The CD-ROM works and I install the missing drivers from this point. The BIOS still shows no CD-ROM drive.At this stage I am not going to argue with the system, been working on it for almost 3 days. First sign that the system is not going to work for me, I am going to scrap it and get a Duron! Wasted too much time on it already!
Good luck, if you manage togo around the problem, post the finding, I am damm curious!

by dcosgrove

I don't think win 98 will even run setup util on a machine with no co-proccesssor. I have also had a tough time with old reel-magic cards and the old sony proprietary type cd drive. that cd is probably not plug and play soyou will have to use an install program or edit you start up file to load the right drivers.

by wlbowers

That old set-up was a propritary buss cd rom that had the cd buss on the sound card. If loading drivers didn't bring it back. Rip it out and replace the sound card and put in a ide cdrom. Those things were a pain when they were new.

Lee

This discussion is closed to new replies.