Discussion Locked

NT WS 4 not conn to Doman

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a WS and Server, all other computers see server but one. Tryed reinstall's new cat5 cable. Nic card. all that, any one help me out ??

thanks

7 replies

by qb4006

Other options you can look at are
1 the NIC drivers
2 The protocol you are using (TCP/IP etc)
3 The possibility that the data jack in that office or on your patch panel is bad - try plugging it into a different jack
4 Computer name may be a duplicate

by green lantern

Are you running TCP/IP, NetBEUI? If running TCP/IP are your addresses and subnets correct? Can you ping each other? Are you using lmhosts files and are they good? Is Client for Microsoft Networks installed and operational? Are both machines in the same workgroup? Are all cables operational?
So many questions, so little information in your post. Please elaborate.

ralph

by avi_mohod

Hi,
First of all if u r using TCP/IP ping to server to very that it is hardware problem or software.Befor pinging check that u have given the workstation proper IP address and subnet mask of network.Now ping to server.If not pinging remove TCP/IP protocol and reinstall it.Also remove nic drivers and reinstall it.After doing this if still u r not geting connect to server then it may be hardware problem.Plz also check hub/switch port.

If ur pinging to server but still u r not able to see server then first of check domain name.Then go to netwok applet in control panel check all necceary servies r added and running.Check if ur properly logon to server.

If this recomdeation not help u plz give the full details of what u have done.
avi.

This discussion is closed to new replies.