Question Locked

old harddrive from old computer will not wrok in brand new computer

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
i have a quantum fireball plus harddrive that has 20.5 GB. we took it out of our old computer hoping that we could save the music and documents on it. we tried to put it into a brand new Emachines, and it wouldnt even boot up. is there some kind of do it yourself info i could find on it, or is there no hope for it?

4 replies

by ic-it

If your boot drive is EIDE; You will need to check the jumper settings, insure that it is set to CS (cable select) or slave. Then add it to the middle section of either the main IDE cable or to the secondary.

by dr dij

some older drives don't work with newer systems despite compatability claims.

Even if it doesn't boot,hook up the old drive as only drive in esystems and goto bios. see if shows up. If it shows up is recognized, should work ok as slave as mentioned above.

if not show at all then not appear to be compatible with new controller.

by leadfoot_116

Most of the time when you connect another hard drive to a computer you have to arrange the jumper shunt or shunts (on the back of the hard drive) set to "slave". If it's not set to "slave" your computer won't know which hard drive to boot your operating system from. The label on top of "old drive" will show a diagram of these settings: MASTER, SLAVE, and CABLE SELECT. just follow the diagram. If you already did this you might want to troubleshoot for things like inserted upsidedown cables or loose ones. also in a rare occurance check your master hard drive to make sure it's set to "master". If it ain't the slave drive won't work.

This discussion is closed to new replies.