Discussion Locked

One slave HD is showin 2 drive letters?!

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Here's the deal:
OLD Config:
windows 98se
IBM deskstar 15 g as Primary1 - Master with slave setting
IBM DeskStar 30 g as Primary 2 - Slave setting
CDRW as Secondary 1
Secondary 2 - NA

NEW Config:
windows 98se
IBM deskstar 15 g as Primary1 - Master with slave setting
WD 60 g as Primary 2 - Slave setting
CDRW as Secondary 1
Secondary 2 - NA

Every thing was fine in a previous config.
In new config the WD 60 gig shows up in Explorer as both drive letter D: AND
F:!
WTF?
Device mangier only shows the 2 type 47 drives!
Bios shows only 2 Harddisks.

I have the latest bios and drivers for the MB (Biostar M7VKD).

How can I get Explore to recognize the primary slave as only one drive?
Does WD HAVE to be the boot drive? I hope not.
Thanks in advance,
PW

3 replies

by thechas

Windows 98 does have several known problems with large hard drives.

There is a problem with fdisk, Phoenix bios, and drives larger than 32 GB.
There is a problem with scandisk and drives larger than 64 GB.

I personally try not to mix drives or memory in order to maximize stability and device compatability.

3 things that you can try.
1. Go to the Windows update site. If you havn't installed it, there is a large drive update that is only available from Windows Update.

2. Move theWD HDD to the secondary channel as master, with your CD-ROM as secondary on either channel. This will keep the IBM as your boot drive, and verify that there are no conflicts between the 2 different hard drive BIOSes.

3. Set up the WD drive with WD drive tools. A floppy comes with retail drives. Or, you can download the tools from WD if you bought a bulk drive.

Good Luck!

by kermudgeon

Sorry
The answer is:
FDISK didn't partiton all the disk, only half. Windows fubared and saw 2 drives. I needed PartionMagic to actually partition and set up the whole drive. FYI: the WD software was a BIG failure. It made windows 98se crash when copying files to the new disk.
The patch is for drives over 64 gb, this is a 60 gig. I had downloaded that patch after the partionmagic, so that, in the future I would be able to fdisk.
I had Award bios, latest flash; drivers.
Thanks for your input.

This discussion is closed to new replies.