11 replies
by shmaltz
Is this only to one address that it doesn't work?
If it is it might be that your IP address and/or domain is on spam list which blocks it from your computer. To troubleshoot this: on the Exchange Server open a command prompt and type telnet mailserver 25, where mailserver is the mx record and/or IP Address to an SMTP server. If you get a reply then you can esteblish an SMTP connection, and try sending mail using SMTP commands;
1. helo domain.com
2. mail from:
3. rcpt to:
if at this point you received an error see what the error is, other wise proceed.
4. data
5. from:your email addressd
6. to: recipients email address
7.
Blank line
8. .
just a dot.
if you receive an error note the error.
If you can't connect from your exchange server (you get an error when you enter the telnet command). Then check your IP filtering and firewalls.
by service
by service
Tou have to configure a gateway .
open the exchange mmc .and add a smtp connector .
in the address space type * so all smtp trafic wil go by that connector.
for more info click help and type smtp connector
by service
by dmatlock
by service
by colin
Create a connector in exchange and tell it to always deliver via DNS.
Make sure that the dns server of the mailserver is your internal dns server. Make sure that forwarders are enabled on the dns server and give it the ip of your isps dns server as a forwarder.
by service
by service
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending