Software

Ask something
Question Locked

PIX 501 setup issues

0 helpful
2 replies

by vwsportruck

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I've been left the remnants of a project requiring several PIX 501 firewalls to be setup within our network. I have the 501's and am able to pull the configuration from "completed/installed" 501's for this project. I have mimicked the settings from the "good" boxes on our remaining boxes, making the appropriate inside/outside IP changes and access-list changes allow traffic in/out of this subnet.

My big problem is that these new boxes are not able to be pinged from inside or outside. I have my machine's IP defined in the access-list as one that should be allowed in (based on the previous person's settings) and have it listed as an SSH and http just as they had done, so I'm not sure why I can't ping these 2 new firewalls. Any thoughts? I'm obviously missing something but not sure what.

Thanks in advance!

2 replies

by synner

Not seeing the configuration, I can only suggest looking at the ACLs again, where the ACLs are applied and add in a:

fixup protocol icmp

This discussion is closed to new replies.