Discussion Locked

POP3

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Where do I start...OK...here goes.

I have a GroupWise system. The GWIA is configured for POP3 on port 110. I also have a Spam Filter server. We are using Surf Control E-Mail filter. I have a cable router. I have the following ports configured: 110 is open and directed to the GWIA server. 25 is open and directed to the Surf Control server.

Inside the firewall I need to set incoming and outgoing server to GWIA and it works in both directions. Outside the firewall I cannot even log in. I think I need to open port 25 to the GWIA server - but when I do that, POP3 still does not work AND then my company cannot send mail. They can receive but not send.

High point value...really need to resolve. Any help is appreciated.

6 replies

by jklein

The root of the issue may be that the Workstation is trying to send AND receive mail to/from one point it sounds like you have two separate stops between the router and your workstation (the GWIA Server and Surf control). Try going with a 'linear' design.
Router > GWIA > Surf Control > Workstation.
GWIA and The Sruf Control can be switched if needed, however, you will need at least ports 25 and 110 open in both directions on each appliance.

by curacao_dejavu

1:
groupwise is your mail server , thus at the client side in outlook/outlook express , you have to configure the incoming and outgoing mailservers to the groupswise mail server.

2:
normally port 25 needs to be open and redirected to the mail server. In your case port 25 needs to be forwarded to the surfcontrol and a: surfcontrol has to forward again to groupwise or b: groupwise to be be configured to receive email from surfcontrol.

3: at the client the smtp server has to be the groupwise server.

http://tinyurl.com/2k6wx
is the firts one your setup ?
did you check the userguides already ?
email me if you have any questions.

Leopold

by megtek

yes, this looks like my config. currently, port 25 is open to surf control and surf control (which doesn't actually have port 25 listening on that machine) forwards to groupwise. Do you suppose my problem is because I only have one ip address, and the router says port 25 is the private ip of surf control, when pop3 needs to see it as gwia?

This discussion is closed to new replies.