Discussion Locked

Printer Sharing with HP4050

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm currently working with a small network runing NT4.0 sp6a, I need to access a HP4050 laser printer on a Windows 98 system, all the other users can access the printer but the NT server cannot. All users have printer access and are using Win 98 workstations. I've tryed everything I can think of.

2 replies

by dcassat

You have not supplied all the info but I'll assume some things.

The server needs to be configured with TCP/IP printing protocol.

The printer needs to be on the network with a internal or external JetDirect card and a good cable connection tothe network.

The JetDirect must have an assigned IP address which you can determine by printing the config sheet at the printer. If it does not have an address you can assign one by installing IPX and HPJetadmin on a workstation to communicate with the card. You can also assign an address at the control panel of the printer but it is a little tedious. The rest is done at the server assuming that the printer address and subnet mask (255.255.255.0) is set correctly.

At the server, add a printer and add a (local) port. Use LPR as the protocol and in the first box enter the address of the printer ie: 192.168.1.15. In the second box enter a short name for the printer ie hp4050.

Add a printer driver, you can use the HP 4 Plus driverfor this purpose and later use the correct driver at the workstations.

Now you have a driver and printer established. Share the printer with a easy name like hpcolor. Verify the connection by printing a test page.

At this point you can browse from any workstation while adding a printer, locate the hpcolor share and select to go with the driver. You should be set. Repeat on all workstations that need access.

I hope this helps and sorry if I went the wrong direction!

by ig-88

Thanks Dan, But I dont have Jetdirect on the HP4050, its connected to a windows 98se system via the standard printer port. The Jetdirect is optional for the printer. Do I have to break down and purchase a jetdirect card? I dont want to move the printer from its current location and install it on the NT 40 server. The network is small, NT 4.0 server with 5 Win98 workstations.

This discussion is closed to new replies.