General discussion


problem with eth0

By yasasvi ·
I am having a box with P-III/866MHz,128 MB RAM, 30 GB HDD (15 for Linux/15 for win2k),Realtek rtl 8139 NIC.I installed redhat 7.1 on the box and it's unable connect to lan.I have configured it using netconfig (console) and I tried netcfg (xwindows).But it's of no use.It recognizes ethernet card well (rtl 8139too--from /etc/modules.conf).I have used modprobe as well as rmmod.But in vain.There is no hardware problem as it works well with the Win2k and while in linux, the green light is on the back side.So, there is no problem with the hardware and setup ( as I am pretty much comfortable with the setup).I downloaded latest drivers from realtek and installed, but was of no use.

Does any body tell where I did mistake?

Thanks in advancesuresh

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Back to Linux Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums