Discussion Locked

RAID or not.

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi you may think this is simple but I am trying to mirror my IBM servers disks.I think I have succeeded but how the hell do you know for sure.Is there some test I can do to verify that the second disk would in fact take over after failure.
I copiedsome sytem files (boot.ini,ntdetect,ntldr)to a floppy edited the boot.ini to reflect the mirrored disk and rebooted using the floppy.It does'nt boot which is good (I think)but I really need to know if it will take over after primary disc failure.
Does it auto take over or is there some work to be done beforehand.Any help appreciated, & thanx for your time.

7 replies

by manuela

Is this hardware RAID? If this is the case and the server is not production yet (ie you can afford to reconfigure it if there is a corruption), you should just pull out or disconnect the first disk (if you have hot plug drives, you can do it on the fly): a proper hardware mirror will ensure the other disk will still operate, with a loss of performance though. Once you re-add the missing disk, the array should reconstruct to the original state automatically, even though it'll take a while. Warning: a Compaq server will behave like this, I have never configured an IBM. Best of luck.

by frobo

Hi gary,

i think you installed the disk mirroring feature of NT(Raid 1). The SW mirroring solution is not the best solution in fact, but better then nothing. If the Master Disk gets defect, you had to reboot and break the mirror. This solution could only mirror the data in the NTFS partition, it could NOT mirror things like Boot and Master Boot Records, their for you have to create and test your NT Boot-disk. If You replace the first master drive, you had to install NT. You don?t have to finish the config of the Install, you want only the Partition and the Boot-Records. Last, boot from Floppy and reinstall the mirror again.

Frobo

by mark_taylor

Assuming SW Raid, all you need to do is bring the server down then disconnect the primary disk and put the second one in its place then boot.
Cheers
Mark

This discussion is closed to new replies.