Discussion Locked

Redhat Linux 6.0 no monitor output

0 helpful
8 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I am running Redhat Linux 6.0 on a PIII 450 mhz w/128 mb. This PC runs some batches to run expect scripts on our SCO system overnight. Quite often - not always - I come in to a blank screen on the monitor. The Linux box is still running and I cantelnet into it from my PC on the network but I need to know how to get the monitor screen back on the Linux box without rebooting or even better stop it from going blank in the first place. I leave it at the Linux prompt and not in X at night.

Also this Linux box defaults to the wrong time when I reboot. I've checked the CMOS setting and that is right. The time is about 5 hours prior to our current time.

Your help is appreciated in advance.
Thanks
Sarah

8 replies

by idtent

The screen is most likely going blank because it is suposed to. Try starting a second login (alt F2) or move the mouse like the same way a screen saver goes. The time issue - I'd be willing to bet that you are on the east coast and that you are off from GMT five hours. Change the setup so that it doesn't think that the time in your BIOS is set to GMT or change the clock in your CMOS to GMT. I hope I offered some assistance - regardless good luck and please note what worked or what happened when you rate the answer.

by seafitch

It was set to GMT Kevin's answer had the correct option to change. I hope I've fixed the video. Time will tell.
Thanks

by cyberlizard

In regards to your first question, it sounds like the power management features of your system's BIOS are set to either suspend or shut down your monitor after a set period of time. Check your BIOS settings and see if there is an option to turn offthis feature.

For your second question, IIRC, you can tell Linux that your hardware clock is in GMT, so it will adjust your software clock accordingly. I assume you're in the eastern time zone of the US? I'll dig a little and see where this setting can be changed.

Aaron Wadley

by seafitch

I changed the video off ater standby to NA and haven't seen the problem recur so far. Thanks for your help.

by kevin anderson

Hi Sarah

Check in the BIOS of your Red Hat box, and disable power saving features.

As for the time, the others are right, this is most likely a time zone issue. In RH6 the easiest way to change your time will be to type /usr/sbin/timeconfig.I believe (from memory) this will go through a menu with you which should allow you to choose a timezone from the Linux prompt.

Kev.

by seafitch

You were right about /usr/sbin/timeconfig. The Hardware Clock set to GMT had an asterisk in it. Removed it and seems ok now. Thanks for your help. Sorry about being so late with this reply. I wasn't able to reboot the server until last night.

This discussion is closed to new replies.