7 replies
by pcouto Accepted solution
by Former member Accepted solution
Your Linux-based Capio One auto-starts the Grid Center client, and you
can login to a Blade from the login screen that is displayed. If you need to
log in to the I/Port to change configurations, the default administrator ID
and password is "root / clearcube" . No default user ID is configured.
If you are using your Linux-based Capio One as a client managed by Grid
Center, do the following from the Grid Center Console:
Go here:
http://www.google.com/search?hl=en&q=Neoware+Capio+One+manual&btnG=Search
And download this, it is a PDF format:
""[PDF]
Quick Start Guide
File Format: PDF/Adobe Acrobat - View as HTML
Outside the US:. +1 (512) 652-3400. Please do not contact Neoware for support issues. ClearCube will provide hardware warranty support for your Capio One"""
Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.
by pcouto Accepted solution
by pcouto Accepted solution
by shasca Accepted solution
There are two ways that we enable ourselves to get into any PC we setup here.
Are these PC's joined to a Domain? If so you could login with a Domain account and access the appropriate areas needing to be addressed. You could also overwrite local policies with a domain group policy.
If these PC's are not part of a domain, and just part of a workgroup you will need a local admin account that was created when they were first setup. This would let you login and do what you need to with the limited user account.
by Former member Accepted solution
Clearing the Password
1. Boot the terminal and hold down the shift key which brings you to a boot prompt at which you can enter: >software single. This will boot the OS in a single user mode.
2. The progress bar will appear and then press Alt+F2 to get to the single user prompt.
3. Type: cd /etc
4. Unlock the file system by typing: /sbin/fsunlock
5. Copy the shadow.default on top of the shadow file by typing the following:
6. cp shadow.default shadow)
7. Lock the file system by typing: /sbin/fslock
8. Type exit and the terminal will boot up normally and the password should be cleared.
..........................................
Power Management
This panel enables to set the Power Management options. Options available
might depend on the hardware platform on which the ADDS 5600 is installed
(Processor type, battery?). The most commonly used option is the shutdown
procedure. This enables to specify what behavior is expected when the user
shutdown the unit.
Factory Default Settings
This option will reset all the settings.
This will be in the:
Setup Manager: System - Reset to factory default settings
......................................
Please post back if you have any more problems or questions.
If this information is useful, please mark as helpful. Thanks.
This discussion is closed to new replies.
Trending Software posts
Sort by Trending