Discussion Locked

Router

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

i was just wondering about routers.
We have a cisco router at work. We use NT4.
We have a Sydney office, Melbourne, Adelaide and Brisbane.
We have a direct link to Melbourne and Brisbane but not to Adelaide from Sydney.
We are going to put a direct link to Adelaide aswell.
Does this mean that this is another physical connection to the router so that now we will have 3 cables coming out of the router rather then 2 for the new link??

7 replies

by unixmandt

Based on the info you supplied in your question, it sounds like you have 2 dedicated circuits ("direct links") to the Melbourne and Brisbane offices. If you are going to add a third dedicated circuit, yes you will have three circuits going to the Cisco router. The other common way is to have the router connected to the internet, and it would route the packets to the router at the destination location. this would only require a single connection for all locations, but not be as secure as a dedicated circuit.

Hope this helps,
unixmandt@netscape.net

by stef gerber

Yes i might mean that, depends on how many ports your Router has. what would typically happen is that you will also get a router in Adelaide and connect the 2 routers together.
Enjoy this is the fun stuff!!!

by andygm

A little more information would be needed to give you help. Here is some info to look at: The way you are describing it, you have dedicated Point to Point circuits weather being, T1, 56k or whatever the circuit was ordered/provisioned at. When you have direct point to point connections to your branch offices you have a private WAN, meaning that other companies do not push traffic over this connection.. The most common method used to day is Frame Relay circuits... in which you can have subinterfaces on 1 logical interface. For example say we have all of our servers in Sydney are domain controllers, application servers, Internet connection to isp etc... Now we want to connect say 10 Branch offices so that they can use these resources at HeadQuarters. Their are numbeous ways to do this.. You can order and configure Point to Point circuits, in which case you will need a WIC-1tcsu for each branch office.. or you order a Frame relay circuit and create subinterfaces in which at headquartersyou only need 1 Phsyical interface.. The other gentleman was referring to using VPN over the public internet .. This is fine for small branch offices and Cisco has many solutions for this, even at your edge/internet routers, with just an IOS upgrade.. All you need is the knowledge on how to configure it...

This discussion is closed to new replies.