Discussion Locked

Seagate STT8000A won't load in WinNT

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I cannot get Seagate STT8000A Driver to load or get the STT8000A to function at all on Window NT Server The tape drive stopped functioning about 2 months ago.
The Event viewer gave this message: "The driver detected a controller error on \Device\Tape0".
I checked under Tape Devices under the control panel and noted that it indicatd that the device was functioning properly. I didn't think to take note as to whether the device driver was running.
Instead I attempted to resolve this error by deleting the the driver file "Q157" and then reinstall in.
After I did so I got the following error at the Server reboot: "Error 0020. The System cannot find the device specified."
And Tape Devices under Control Panel now indicated that the driver was stopped. I did not try to restart it.
I then obtained the "tdiag40" Tape Diagnoistic self-extracting file program from Seagate & installed it on the Server. It could not locate the device at all & suggested I donwnload and install the STTSCSI4.EXE which I did.
I loaded this driver in the "Tape Devices" and restarted the Server. I got the same Error 0020.
I checked under the Event viewer and saw this message: "The following boot-start or system-start driver failed to load: sttsci4"
I checked again under Tape Device and it again indicated that the driver was stopped.
I then checked Services under Control Panel and it showed that the drive was not started. I attempted to start it and got the message that the device could not be located.
So, what do I go from here?

5 replies

by jamesmeszaros

Next thing to try, unfortunately, is to place the tape drive in another PC with Win NT there as well.
Also try to put the tape drive in a Win9x machine (download the appropriate drivers and software). If it does not work in other PC's then it is likely a dead tape backup (or controller card if there is one).

by gigelul

In Control Panel\devices, make sure that you have only one driver enabled and the correct driver.

This discussion is closed to new replies.