Discussion Locked

Setup hangs during installlation of Win2

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I am performing a new installing on a machine which previously had windows 98 on it. All the files are copied from the CD to the hard drive and setup asks me to reboot. Once I reboot, I get the message "Setup is inspecting your computer's hardware configuration". It justs hangs there and does nothing. Any suggestions on how to unfreeze it?

4 replies

by montea7

Not any info on your system so I am going to just give you a clip from a Microsoft article.

SYMPTOMS
When you install Windows 2000, the computer may stop responding (hang) while the computer displays the "Setup is inspecting your computer's hardware configuration" screen.

CAUSE
This behavior can occur if a disk controller is configured to support removable media as fixed disks.

RESOLUTION
Turn off the features that treat removable disks (such as Iomega Zip or Jaz disks) as fixed disks in the disk controller's BIOS.
On some controllers, changing settings in the disk controller's BIOS requires that you press a certain key combination during the computer's power-on self test (POST). Watch for this information on the screen during startup, or consult the controller's documentation.
Some controllers have options such as "Boot device only" and "All removable media." Setting the option to "Boot device only" often resolves the issue and still allows the computer to boot from a CD-ROM or other removable media.

by akhurana

I already had looked at that article and it didn't help much.. i changed the BIOS and CMOS settings which didn't help. My system has 64MB ram and a g gig hard drive. it is a Pentium 200. The problem could be because of less memory.. but how do i correct it without addign more memory?

by mikel~t

Have you tried running the installation with the switch /checkupgradeonly. It sounds like a hardware compatability issue.

Mike

This discussion is closed to new replies.