Software

Ask something
Discussion Locked

Syntax error, command unrecognized

0 helpful
1 reply

by martin_hero

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I GOT THE FOLLOWING MESSAGE , when i send a mail to my client , their mail server reply this mail to me , Would anyone know what happen is it ?

My mail config:
NT 4 SP6
EXCHANGE 5.5

Your message did not reach some or all of the intendedrecipients.

Subject: Mail test Sent:11/6/2003 11:27

The following recipient(s) could not be reached:

support@sea.com on 11/6/2003 11:40
Unable to deliver the message due to a communications failure
The MTS-ID ofthe original message is: c=xx;a= ;p=xxxxxx;l=xxx-0306242338Z-2345
MSEXCH:IMS:xxxxx:xxxx:xxxxx 3500 (000B09AA) 500 Syntax error, command unrecognized

1 reply

by ann777

The 500 error that you are getting, is indicative of a miscommunication... some of the transmission got garbled in all probability.

http://www.wu-wien.ac.at:8082/rfc/rfc821.hyx/rfc821.13_b4.2._bSMTP_bREPLIES

(Please remove any embedded spaces from the above link when pasting it into your browser)

Have you been able to send/receive anything from the same e-mail address? Have you checked with the person you are sending to -- make sure the address has not changed or they are not havingprobles that they know of with their Internet connectivity or their mail server?

This discussion is closed to new replies.