General discussion

Locked

T3 digitizer mayhem

By lyon_bleu ·
My Tungsten T3 is having difficulty tracking the stylus properly
when in the "extended" position. When "closed," there is no
problem setting up the digitizer. When "open," the stylus tracks
consistently about 1/4" above where I touch the screen, making
it impossible to access the lower menu bar, unless the screen is
rotated.

I suspect I may have inadvertently installed a "hack" that is
interfering with the proper tracking.

A) Are there any known conflicts I should look for?
B) How can I print or save to file a list of what is installed so that
I can more easily review it?

TIA

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by lyon_bleu In reply to T3 digitizer mayhem

Just noticed that it behaves the same way when the screen is
rotated, ie the stylus tracks about 1/4" to the right when I touch
the left-most part of the screen; it's beginning to look a lot like
hardware

Collapse -

by shripalkkad In reply to T3 digitizer mayhem

Hi,

Please perform a System reset if not Hard REset after synchronizing your Palm with the computer to save data. Before synchronizing the device with your computer, check if the issue persist. If it is resolved, then the issue is with some third party software installed. Try uninstalling it and check the device.

Regards,
Shriram.v

Collapse -

by lyon_bleu In reply to

Poster rated this answer.

Collapse -

by lyon_bleu In reply to T3 digitizer mayhem

Thanks for the troubleshooting hint, Shriram. It is indeed
hardware-related. FWIW, setting up the digitizer by touching the
_top_ of the target instead of the _center_ is a decent work-
around until I can get a replacement.

Regards,

paul

Collapse -

by lyon_bleu In reply to T3 digitizer mayhem

This question was closed by the author

Back to Other Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums