Discussion Locked

Taking advantage of a phone company.

0 helpful
17 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
At home, I am able to access the internet and the phone, but only one at a time. but then this "Sympatico" internet service comes out and says that they can do internet and allow you to talk on the phone for a fee. I dont wish to pay a cent. Then I looked on the net one day and found out that the wall jack consisted of 4 lines. I assume 2 of those 4 wires are just for input and output. If I'm not mistaken, I could use 2 of the wires for phone data and the remaining 2 for the internet. How do I do the wiring so I have both the internet and the phone working at the same time? does the black wire and the red wire go to the modem? explain.

17 replies

by james r linn

Sympatico High Speed = ADSL service, which does use the other pair for its networking. To use this service you get a network interface card and a DSL router that use the other pair (if you are "close" to the central office, and they setup the pair at the central office for you). Its about 40$ (Canadian)a month, and they often run specials which waive fees for installation. Thats about the cost of buying a second line
and paying for your ISP, but is much faster.

But you can't use that pair for an analog modem, unless Bell Canada configures it for a second phone line. You only have one active pair.

There is software out there which will allow you to pause your internet session while you take a call or make a call. Sprint advertises itas Internet Call waiting - I think Nortel wrote it. You can buy that for a reasonable cost, but I've never used it.

James

by mike (from canada)

Well, the answer you gave me was sort of what I was thinking, but your answer does not show the configuration of the wires. That is the most important part.

by b_pope

it would matter what config you use, you won't be able to surf & talk without them hooking your line into high speed circuitry back at the switching station,or you get a second phone line.

by mike (from canada)

Your answer might be true but it is not getting to my point. What I need to know is what each wire does. Is the red one receive? is the yellow one receive? please explain that.

by shiny_topadm

Hi, I'm really not sure if Canada wiring is the same (it should be because I think it's a "North American" standard), but [disclaimer: in the U.S.] standard RJ-11 wiring practice is 1 pair (red and green) is connected to positions 3 & 4 and designated "R" and "T" for ring and tip (nomenclature left-over from mechanical patch-cord days). This pair is used for a single phone line. A standard analog phone line only uses that one pair. If a second line is connected, it uses the yellow and black pair and gets connected to positions 2 & 5. If you haven't contracted for more than one line, you won't get a dial tone on the second pair. xDSL service could be installed to use either pair. Sorry, but you can't get something for nothing...

by shiny_topadm

just for further clarification: the yellow and black pair perform the same function as the red and green pair, IF (outside of your house) they are connected to two phone circuits (2 numbers, or 2 lines). If you only pay for one line, the second 'pair' will not be active. sorry

by dcosgrove

Sorry, there is no way to do what you ask. The outer pair of connectors is for a second phone line. There are only 2 wires comming into your house from the telephone pole and they are ring and tip (one open cicuit). DSL seperates the bandwidth ofthe phone signal using the peeks for internet and the bases for voice. Cable obviously uses your cable tv lines. There are programs and devices which will suspend internet when a call waiting signal is received and ring your phone. I, however, ama big believer in the statement "you get what you pay for".

by dcosgrove

There may be four wires but only two are used. Ethernet has eight wire but only four are ever used. If you look at the box on the outside of your house you will see the phone company only runs two wires per line. In short, you CAN NOT use the same phone line for two sessions, period.

by james r linn

It doesn't matter, its a moot point. If you pay for one phone line, you may have 4 wires coming in but only 2 (a pair) are active at the central office, which is the switching site that connects your phone with the rest of the world. The other pair is dead, unless you pay your phone provider to either configure them for another phone/modem, or for DSL/High speed Internet.

There is no free phone service just lying around.

James

by searogue

Hi, I used to do some work with phone lines & installed security systems for about 2 years as well. Answer #3 is correct. Green & yellow are one pair, black & red are the other pair, you can only use one pair at a time unless you are paying for 2lines. The actual colors of which 2 wires are connected doesn't really matter as long as the same two are connected at both ends, but the example givem by answer #3 is correct. To answer your question: You cannot "do the wiring so you have both the internet & telephone service" off one phone line at the same time.

Regards,

Tony

This discussion is closed to new replies.