Discussion Locked

Two physical drives, but only one instal

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm running Win 98se. I have one 10 gb drive. When I start windows it show that there are two 10 gb drives. I ran FDISK and it show 1 10 gb drive with C: assigned to it. But when I start Windows it show C: and D: both at 10 gb. What is causing this to do this.

5 replies

by thechas

Windows can get confused and "ghost" duplicate drives.

Before attempting a fix, are you sure that you only have 1 drive?
Please note: fdisk only looks at one physical drive at a time.
Run fdisk again, and use the option to change physical drives to check for a second drive.

You can also either enter BIOS setup, or watch the startup POST screens to verify if you have one or 2 drives installed, and the physical size of the drive(s).

If both drives show the same inforamtion in Windows Explorer, then the drive is indeed ghosted.

Try either;
Installing an updated IDE Bus driver for your motherboard; Check with the system / motherboard / chipset mfg for an updated driver.

Or, from device manager, remove both drives and the IDE controller. Reboot windows, and it should find only the real drive.

Chas

by ellisla

After I removed the devices, and restared. It placed both drives back the way they were. I had to rebuild the system to corect the problem.

by gigelul

About removing from device manager both IDE drives and IDE controller. Possible that your system freeze after that. After restart depend by the integrity of your OS if it can or not to reestablish these. Save your data before does that.

This discussion is closed to new replies.