Discussion Locked

Windows NT 4.0 Fault Talerant Boot Disk

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Scenerio:
Windows NT 4.0 SP6 installed and functioning on a 4 GIG partition of a 30 GIG IDE Disk ID 0
This partition is Mirrored to an 18 GIG SCSI drive Disk ID 1. Both the drives are functioning and the mirror is intact.

Where do I go to create a Fault Talerant Boot Disk. I have read articles on MS TechNet on how to create one after a drive failure. But was unable to find a proceedure for creating one while everything is functioning. I am assuming there is a tool or a wizard built into NT 4.0 which will allow me to create a Fault Talerant boot disk.
If some one could supply me with instructions on how to accomplish this I would appreciate it greatly.

2 replies

by vstoneman

Thank you ever so much I did not see this article when I searched TechNet before. This is so much clearer. Thanks! I was really hoping for a wizard or automation of some sort. But this will have to do.

This discussion is closed to new replies.