Question Locked

Windows XP Pro +SP2 Repair Re-Installation Fails

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Can anyone please help. I have tried to carry out a Repair Installation but when Windows first reboots after loading all the files, it reaches the Logo screen (with the scrolling bar) and then just 'Hangs' indefinitely. After that I can no longer boot-up at all, it just takes me to the Logo screen again and guess what - it hangs again.
I have a lot of data on my 300GB HDD which I don't want to loose otherwise I would do a 'Fresh Install'. An earlier problem I found when I tried to boot-up in 'Safe Mode' was that after it had finished loading the drivers (the last one being 'Mup.sys' again it just hangs. I don't know if the two are related but this is what prompted me to do a 'Repair Re-Install' Any ideas anyone (I have 2GB of RAM installed).
Thanks, Bob

5 replies

by oh smeg

Windows isn't properly installed and the Windows Installer is attempting to finish the install.

As to the hanging try to rerun the In place install. If that continues to fail you will need to remove the HDD and use it with another computer to recover your data. Though if you where using XP Pro and Windows Encrypted File System it will currently all be encrypted and your Encryption Key will have been deleted and you will need to recover your Encryption Key from your Backup.

If you don't have a Backup of your Encryption Key you will need to take the HDD to a Data Recovery House to recover your data.

Col

by hutchy80

Many thanks for your reply, sorry it's been a while for me to reply. however, I finally copied all my data to another HDD using the 'Bart PE' software, then did a fresh full installation. The only problem was that I had to re-install all my other software programs and then copy the files back from my other HDD. So I am now up and running again. I still don't know however why the 'Repair Install' didn't work even though I used the OEM installation disk for Windows XP +SP2. Why didn't it do it's repair install, I thought that was what it was designed to do, "Repair" the installation and load the necessary files to run an installation procedure to completion.
Best regards & thanks again,
fivetiles

by mayhem1969

Sounds like you have a hardware conflict that is preventing SP2 from loading. I have read this may be a problem related to USB 2.0 devices. Try removing those devices and install with minimal configuration.

by hutchy80

Many thanks for your reply, your help is appreciated. However, I am not sure how to remove any USB related devices as I couldn't access Windows to do this. Also, how do I do a 'Repair Install' with minimum configuration, I didn't know I had a choice.
Best regards,
fivestiles

This discussion is closed to new replies.