General discussion

Locked

2 network cards connected to 2 routers

By Linux Surfer ·
i started off with a pc (NT4)on a tcp/ip local network connected to hub is a cisco router for lotus notes and a citrix terminal. the customer then wanted to connect to a second router and run another citrix program not at the same time so after installing a second network card and assigning a gateway to that card as well. i can ping both routers, when i try to run either of the programs i can sometimes connect but most of the time it fails to to get to either server on the other end of the routers when there is one card in a pc there isn't a problem is there a way of making sure the cards only look for there own router.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

2 network cards connected to 2 routers

by MauntelJW In reply to 2 network cards connected ...

You need to use the "route add" command from a command prompt. This will allow you to direct certain traffic through a certain NIC.

Collapse -

2 network cards connected to 2 routers

by Linux Surfer In reply to 2 network cards connected ...

thank you for your answer it help but did not completely fix the problem. i will keep trying

Collapse -

2 network cards connected to 2 routers

by Linux Surfer In reply to 2 network cards connected ...

This question was closed by the author

Back to Networks Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums