Discussion Locked
0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
Installed 2 256 RDRAM chips in a Gateway 700x that had 512MB. BIOS sees 1 G but Windows 2000 Pro only sees 512MB. Any Thoughts?
6 replies
by saihib
Try swapping slots and running the new memory by itself to see what happens.
by sutherlajr
Thank you for your help. This procedure failed to produce any changes. Again, Thank you very much for your thoughts!
by dmiles
First check the motherboard manual or go to manufacturers web site to see if the mother board will support more than 512mb of memory.
If the bios is detecting the memory then I am not sure why Windows see's only 512mb,it does not seem logical if the BIOS is detecting that windows is over riding
by sutherlajr
Thank you for your help. This procedure was checked and the mother board will support up to two G.. Again, Thank you very much for your thoughts!
by vt100
If BIOS did recognize memory increase, after booting to GUI, run "Scan for hardware changes" from "Device Manager" in "My computer/Properties/Hardware"
Regards,
Vladimir
by sutherlajr
Thank you for your help. This procedure failed to produce any changes after RAM was installed.. Again, Thank you very much for your thoughts!
This discussion is closed to new replies.
Trending Windows Forum posts
Sort by Trending
1 helpful
17 replies
0 helpful
5 replies
0 helpful
12 replies
0 helpful
2 replies
Question
Is WSL still relevant in 2026?
0 helpful
1 reply