General discussion

Locked

3com hub issue

By steve ·
I have a sight that has an RS/6000 attached to the LAN that our office supports. My contact over there was informed to set the NIC in that box to be @ 100Mbs/ half duplex. This person was informed to set the corresponding port on their 3com super stack II, dual speed 500 hub to be 100Mbs also.

My question is this; is this possible, and if so, how is it accomplished?

Any suggestions would be greatly appreciated.

Thank you for your time,

Steve Danaher
Network Support
Campbell County Government
steve@ccg.co.campbell.wy.us

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

3com hub issue

by calves In reply to 3com hub issue

I have the same Hub here and as far as I know the Hub uses an autosense technology, meaning that will detect the NIC need and provide it according.
The NIC is the one that should lead the configuration. you should have the option to configure yourNIC with the proper speed @ the RS6000.

Good luck!

Collapse -

3com hub issue

by steve In reply to 3com hub issue

The question was auto-closed by TechRepublic

Collapse -

3com hub issue

by Michael Roark - CCNA/DA MCP 3CSA In reply to 3com hub issue

The 3Com Dual Speed Hub is indeed autosensing, so no worries there.
as far as changing your NIC to 100Mbps @ half duplex, that should be in network neighborhood, under the properties of the NIC itself. If you have difficulties with this please feelfree to Email me and I can walk you through it.
Good Luck.

Collapse -

3com hub issue

by steve In reply to 3com hub issue

The question was auto-closed by TechRepublic

Collapse -

3com hub issue

by steve In reply to 3com hub issue

This question was auto closed due to inactivity

Back to Desktop Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums