General discussion

Locked

3com NIC

By itpro128 ·
We installed 3com 10/100mbps NIC card to IBM P1 machines which already has 10Mbps inbuild.But we still receive 10Mbps output despite we use 100Mbps capable Cisco Switch?What could be our problem??

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

by LMon In reply to 3com NIC

Right click on the 3com card select properties. You should get the Properties screen. In the "general tab" select configure (make sure the card is the 3comm card) then go to the "advacned" and check the link speed\duplex mode it should be on "Auto mode" but can be changed to whatever you want. If that does not change anything and you have a manageable switch I would check the switches settings to see if they are at 10Mbps or 100 Mbps.

Collapse -

by itpro128 In reply to

Poster rated this answer.

Collapse -

by itpro128 In reply to 3com NIC

This question was closed by the author

Back to Networks Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums