General discussion

Locked

80 Conductor Cable Problem

By ramesh_verma_85 ·
All Expert,

When i boot me PC. It is show the "Primary IDE Channel 80 Conductor Cable Installed. Please Tell me the solution

thanks

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

No_Primary IDE Channel 80 Conductor Cable Installed?

by seanferd In reply to 80 Conductor Cable Proble ...

Make sure cable connectors are fully seated, and that each connector is connected to the proper device. If the cable has been newly installed, make sure that it is not a 40 conductor cable by mistake.

Collapse -

that's an informational message, not an error

by robo_dev In reply to 80 Conductor Cable Proble ...

does the PC boot normally or not?

ATA interfaces will work with a 40 or 80pin cable. It runs faster with 80 pin cable.

Collapse -

Yar. I was hoping to find out if there was a "No" involved.

by seanferd In reply to that's an informational m ...

Is it a problem or just info? Perhaps we'll never know.

Back to Windows Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums