Hardware

Ask something
Question Locked

Adding memory in Microsoft Windows XP

0 helpful
2 replies

by roberttnbradley

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I need to add memory to my cpu, and need to get the actual steps to perform this update.
I have already purchased an additional memory card. Is it a simple switching of cards, then powering the system back up?

2 replies

by thechas

It is sort of just as simple as shutting down the system and changing the RAM modules. At least as far as Windows is concerned.

Since it sounds like you are new to this, there are a few things to keep in mind.

1. Make sure you have the correct memory for your system. Not all SDRAM or DDR modules work in all systems.

2. Know and follow ESD safety precautions. The best is to wear a properly grounded ESD wrist strap while working on the computer. The second best is to have 1 hand ALWAYS in contact with a metal part of the case.

3. Make sure to orient the memory module properly. the notch in the connector area of the module is used for both polarity and type keying. Do not use excessive force on the module.

4. Depending on the age of your PC, it might be wise to start by blowing off the dust with canned air.

5. While you are changing RAM, it is often easy to knock a connector or plug-in card loose. Make sure that all of the cards and connectors are seated.

6. When you have the new RAM installed and power up your system, the BIOS may recognize that the amount of RAM has changed and will generate an error. If it does so, just press the key to enter BIOS setup, then, save and exit.

So long as you have the correct RAM, that should be it.

Chas

This discussion is closed to new replies.