General discussion

  • Creator
    Topic
  • #2093198

    Autocad/Invalid Page Faults/KRNL386.exe

    Locked

    by jdrake ·

    I am running into troubles opening a file from a zip disk resulting in the following error:

    ACAD caused an invalid pagte fault in
    module KRNL386.EXE at 0001:00003577
    Registers
    EAX=00003ccfCS=0147 EIP = 00003577 EFLGS=000000282
    etc. etc. etc.
    Can anyone cast some definitive light on this subject and how to remedy this problem?

All Comments

  • Author
    Replies
    • #3869463

      Autocad/Invalid Page Faults/KRNL386.exe

      by istmaj ·

      In reply to Autocad/Invalid Page Faults/KRNL386.exe

      Question: Do you have anything else open or running? Invalid page faults occur because of several reasons:The virtual memory system becomes unstable due to a shortage of physical memory (RAM),the virtual memory system becomes unstable due to a shortage of free disk space,or the virtual memory area is corrupted by a misbehaving application or an application attempts to access data that is being modified by another running application. I suggest you check RAM, disk space etc. Sounds like you are out of resources to run the progam. Perhaps try shutting down some applications before running the disk. Good Luck!

      • #3871469

        Autocad/Invalid Page Faults/KRNL386.exe

        by jdrake ·

        In reply to Autocad/Invalid Page Faults/KRNL386.exe

        No. This is certainly not the trouble we are having. The machine in question has in excess of 9 gb free hard drive space and we have just (for this reason) gone ahead and bumped up the RAM from 128 to 256. The program is running alone with the exception of background windows apps. The general feeling is that this is a difficulty with RAM access whereby either Autocad itself is attempting to access the same portions of the RAM twice or it is having a similar conflict with another application(ie. an ActiveX control)

    • #3714562

      Autocad/Invalid Page Faults/KRNL386.exe

      by estebandelatorre ·

      In reply to Autocad/Invalid Page Faults/KRNL386.exe

      Try to copy the file to a “enought free space” drive, and then open the file from there.
      This could aviod the GPF in Kernel

    • #3725272

      Autocad/Invalid Page Faults/KRNL386.exe

      by jdrake ·

      In reply to Autocad/Invalid Page Faults/KRNL386.exe

      This question was closed by the author

Viewing 2 reply threads