Discussion Locked

Award BIOS won't detect large HDD

0 helpful
7 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I'm running an AMDK6-3 450 processor w/Award BIOS, 2A5LEL1B. Mother board is 5MVP3. I'm trying to install a 40GB HDD but it won't detect it in auto. I put the old HDD (4GB) and the R/W drive on the same cable (Primary M/S). The new HDD is on thesecond cable (Secondary Master). The computer hangs if I set the jumper on the new HDD for Master. I assume it should be on Master if no other IDE devices are on the cable. Since it hangs and I need to use the computer, I've added another jumper. The two jumpers are set according to the WESTERN DIGITAL guide book (both at the end of the jumper block, i.e. the 4th and 5th jumper.) Reading the mother board book tells me that my BIOS probably needs upgrading. The Award website is less than friendly. How do I get the computer to see the new drive?

7 replies

by purplebook

First, upon bootup, get the BIOS information code (along the bottom of the screen), and write it down. When you get online, go to your mainboard maker's homepage and look in the downloads for BIOS upgrades. Download the one that matches your BIOS information code, and install that one, NOTE: Make a backup before overwritting the BIOS!.

The main problem you are having isn't the drive, but the year of the BIOS. It should have the y2k upgrade in order to detect the larger drives. Remember BIOS's from 1998-99 saw drives as large as 8.4 GB!

by rosek

Thank you for your response. Your answer seemed to fit the situation better than the other responses I received. I DID have to purchase a new BIOS. After that, everything went smoothly. Except this pesky web enhancer that kept giving the blue screen of death. Once I got rid of that, my PC performance was killer.

by thechas

On all WD hard drives, the jumper is left off for a single drive. I have never seen a WD configuration calling for 2 jumpers.

Get the jumper correct first. Your BIOS may be able to detect the drive just fine.

If it does not report the coprrect drive size, you have 2 options.
1. Check with the MB mfg for a BIOS update. Award sells BIOS only to OEM MB mfg, not to end users. From the model number, it sounds like it may be a SOYO MB. If not, there are MB ID tools available at www.motherboards.org

2. Use the ez-bios utility provided by WD with the drive.

Either path should get you up and running once you have the drive jumper set correctly.

by saihib

Western Digital hard drives, when running alone, should not be jumpered at all. You're probably right that you'll need to flash your bios to get the machine to recognize a drive that size but I've also used WD's drive overlay software with great success.

This discussion is closed to new replies.