General discussion


belkin router

By wellmax1.maxwell ·
thanks master3bs
I have configured my router.And I have a major problem I can't connect to the internet with my second laptop.I cant access the router using the ip address.I rebooted the computers after the configuration and these problem occur.I there any way I can get the router to the state it was before.

This conversation is currently closed to new comments.

Thread display: Collapse - | Expand +

All Comments

Collapse -

by jc2it In reply to belkin router

Usually there is a factory reset procedure for NAT routers. This varies per brand/model. The belkin I have at home resets when I hold down the button and reboot it. The button is recessed in the back of my router.

Depending on the model your mileage may vary. Check out belkin's web site for your router. After you do this be sure to set up the wireless security and change the admin password. This should only take a couple of minutes and will greatly benefit you later.

Related Discussions

Related Forums