Discussion Locked

Best hardware and methods to deploy WiFi signal...

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

What I am trying to accomplish...

I am going to be trying to push a Wireless signal from a house to another building that is about 1600 feet away. Both structures are in direct line of site of one another. This is for residential use, so commercial grade equipment isn't out of the question, but price is also an issue to keep in mind.

Any thoughts, ideas, or solutions? I have a few ideas in mind, but I'm working alone on this project so its always great hearing others experiences/successes/failures.

6 replies

by big ole jack

mounted on window sills or on the roofs of buildings, similar to what you see on cell phone towers. But, the signal will be adversely affected in bad weather and you need to have a direct and unobstructed line of site to make it work at its best. I honestly don't think you can get WiFi to work at 1600' unless you use a strong signal repeater, assuming they are available on the market, which I am sure they are, but you'll also be increasing the noise to signal ratio as well.

by tig2

At BreezeCom. I've used their stuff in the past but if I recall correctly, it wasn't cheap and it was limited to 1000 feet.

I don't think that you are going to be able to get the distance you are looking for, and certainly not without going to a commercial product.

by big ole jack

I always wanted to find a place that sells stuff to make me glow in the dark from all those microwave signals.....LOL!

by jbafile

Thanks for your input.

I am looking at installing two Hawking outdoor directional antennas. One at Site A to push the signal. One at Site B to receive signal that will attach to an access point that will repeat the wireless signal at Site B.

Again, thoughts or ideas are appreciated! Thank you in advance.

by michael kassner

A bridge link of this distance is entirely possible. I would suggest looking at the first link as it will give you an understanding of what is required to have an acceptable SoM (usually greater than 28dB) for the distance you mentioned. Also make sure you have a clear Fresnel Zone or the link will fail.

http://www.terabeam.com/support/calculations/fresnel-zone.php

I then might suggest using two devices similar to those advertised on the second link (no affiliation). All you have to do is run Cat 5 to the device as it runs PoE. That will save the normal loss attributed to running coaxial cable.

http://www.wlanparts.com/product/ZZ-CBROO/15dbi_Rootenna_with_200mw_NL2611_CB3_Plus_Deluxe_80211b__ZZCBROO.html

This discussion is closed to new replies.