Question Locked

Black screen when I boot up my Presario V3010us computer

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have had my Compaq Presario V3010US notebook computer for 2 years and no problems. I have taken great care of the machine and I have not dropped it or had any liquids in the vicinity.

But today when i went to boot up the computer I did not see any display on my screen. It is completely black. I do not hear the hard drive running but all of the other lights on the machine light up so they seem to be working fine. But I can not start-up my computer.

Can anybody provide any assistance or information on where I can get some help on this problem?

3 replies

by nepenthe0

1) Computer batteries do not last forever. Lithium ion batteries start to lose efficiency after 12-18 months of use, and will rapidly drop in charge. There comes a time when the battery simply will not hold sufficient charge to run the notebook.

2) The hard drive may have failed. I would try removing the hard drive and connecting it to the Coolmax adapter to retrieve important files. You can obtain the $25 adapter at:

http://tinyurl.com/4an8u9

Plug the USB cable into your desktop computer, plug the removed notebook hard drive into the adapter, and transfer your important files. Alas, if the controller or motor have croaked, all is for naught.

To remove the hard drive from the notebook, look for half a dozen perimeter screws and a central screw on the bottom of the notebook, marked by arrows embossed in the plastic. Carefully lift the keypad bezel. The hard drive is easily removed, often retained by a single screw.

If you have very important files on the hard drive, and it has [i]kicked the bucket[/i], there are ways to retrieve your data, but such services are prohibitively expensive.

The first thing I would do is to test the battery. Check the voltage posted on the battery label. At full charge, the measured voltage across the terminals should be close to the designated value. If considerably below that value, the battery has failed.

Even if the voltage is close to the designated value, the battery may still not hold sufficient charge to boot the computer. I would recommend your having the battery tested at a facility such as Batteries Plus:

http://www.batteriesplus.com/t-storeloc.aspx

Replacing batteries and hard drives are [i]do-it-yourself[/i] procedures. More complicated repair normally requires professional service.

Also, check out the excellent Jan'06 TR post by Greg Shultz:

http://tinyurl.com/5tl82j

Hope this helps.

Rick/Portland, OR

by oh smeg

Is that the battery if constantly left on Mains Power can vent excess gases onto the M'Board causing corrosion. When the battery gets hot they need to vent gas to prevent explosions occurring.

As you made no mention of any sound original ting from the unit if on Mains Power and the Mains Adapter is working OK you then have to look at a Hardware problem that affects the M'Board somehow. So look at Power as the first option and check the Mains Adapter for voltage and Current. If the Mains Adapter is constantly left plugged in it can overheat and stop working. If you are attempting to run on the Battery it could have died and need replacing these do fail in a 12 to 18 month period usually so that need to be considered as Disposable items.

If you use this NB a lot and don't have a Cool Pad under it it will run hot and eventually fail much sooner than it would with a cool pad so it may just be a simple Electronic Failure of the M'Board or even something as simple as a Blown Fuse.

You really need to have it looked at for a proper Diagnosis and then decide how to proceed.

Whoops nearly forgot you can find the Service Manual for this unit here as a PDF File.

http://tinyurl.com/2guvrg

Col

This discussion is closed to new replies.