Discussion Locked

Blue Screen of Death and other errors

0 helpful
1 reply
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

Hi,

Are you familiar with these installation errors:

1. *** STOP: 0X0000001A (0X00041284, 0X02E4B000, 0X000006C4)

2. The file <[System_file.any]) was not copied correctly
The file setup placed on your hard drive is not a valid WINDOWS 2000 image. If you are installing from a CD, there may be a problem with Windows 2000 CD.

3. IRQL_NOT_LESS_OR_EQUAL (dumping memory)

4. System Root\System32\Drivers\Ipsec.sys device driver could not be located.

I spend 2 days with less slept not stoping what is wrong with my system.

The story goes like this:

I got two clone computers (Identical configuration) P4 1.4Mhz, 384Mb RAM, 30Gb HD seagate, Motherboard with VIA chipset, Onboard audio, lan card, Vga card on an agp slot, 1 CDRom drive(24x) (internal) and 1 CD-CDR (8x/4x) internal drive.
Clone because small business, but original Windows 2000 server and professional edition were applied.

May be you have some idea on how to resolve the errors that was stated above. Need to have a good sleep. I am frustrated not locating where or on which part of the system triggers the reset of the PC. After the stated errors prompted on the screen, then few seconds machines restarts itself. If you have experienced this before, could you kindly share it with me.

Checking that i made:

1. Check HD
I deleted the partition of HD's and changed to FAT and format it. Ran Scandisk(DOS-thoroughly). I looked at its sectors (Graphical presentation for scandisk) and found no bad sectors on it. Then I concluded that there is no problem with my harddisks.

2. Check cables
Changed IDE cables and still erorrs in blue screen displays.

3. Changed CD drives
Still errors displayed.

Need help really.

Thanks,

1 reply

by ann777

1) "0X00041284" indicates a memory problem--> make sure memory is removed and then reseated it its slot.
2) may be either the win2000 cd or the drive itself --> make sure the cd is clean -- no scratches, cracks, etc.
3) is also indicative of memory issues --> but more of a configuration issue. You said you have two clone computers --> did you image your install and is that what you are trying to load? Are both of these on the same network? Have you run the utility to change the SID if applying from a clone?
4) MSKB Q226442 --> When you start your Windows 2000-based computer, you may receive the following error message:
System Process - Unable to Load Device Driver
\SystemRoot\System32\DRIVERS\ipsec.sys device driver could not be loaded.
Error Status was 0xc0000034.
CAUSE
This issue can occur if the Tcpip.sys file is damaged or is missing. IP Security (IPSEC) is dependent on the TCP/IP protocol.
RESOLUTION
To resolve this issue, replace the damaged or missing Tcpip.sys from the Windows 2000 CD-ROM, or remove and then reinstall TCP/IP.

This discussion is closed to new replies.