Windows Forum

Ask something
Discussion Locked

Browsing LAN in Win 2K RAS

0 helpful
2 replies

by dyau

Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
We have a Win 2000 Server acting as the Domain controller with RAS set up to accept incoming RAS dial-ins via a modem. However, users are unable to browse the network. They can only see themselves on the domain. They are dynamically assigned IP addresses from a static pool. We have active directory set up. Users are largely Win 98 users. How can they view the entire network neighbourhood?

2 replies

by rvkempen

In the server properties of your routing and remote access snapin, you might want to enable ip routing on the ip tab.
If you disabled it, ras users will only have access to the server dialing in to.

Also rras does not take the settings from yourdhcp server (except for the ip address), but from your ras server, so make sure that it has the corect wins, and dns settings.

Good hunting.

by dyau

Thanks for your help, however, the IP routing is already enabled. Even so, dial in users cant even see the server (only themselves)

I am pretty confident we have the correct DNS settings. We dont use WINS.

This discussion is closed to new replies.