22 replies
by dr.llvll Accepted solution
by willcomp Accepted solution
Ensure that CMOS reset jumper is in normal position.
Is 12VDC auxiliary CPU power connected (4 pin square plug)?
If neither of these are the cause, disconnect everyting not required for a basic boot and start there. You should only have motherboard, CPU, memory, PSU, keyboard, and monitor installed/connected.
by dr.llvll Accepted solution
by cg it Accepted solution
but with everything there is always the one that doesn't work. It's possible the board doesn't support the memory your trying to use.
then again it's possible the board is just dead.
If you bought it from Newegg.com RMA and get a different one.
by willcomp Accepted solution
Did you reduce down to bare essentials as recommended previously?
Most motherboards have a piezoelectric (button) speaker mounted on the motherboard. If there is no speaker connection on the front panel connector block, speaker is surely integrated on mobo.
If removing/disconnecting anything not needed for a basic boot does not help, remove memory and see if it beeps.
You did use standoffs to mount motherboard in case and did not place a standoff where ther was no screw hole? Either one can cause a short.
by dr.llvll Accepted solution
by cg it Accepted solution
he's the resident hardware guru...
I don't think that mainboard will it take PC2 6400 memory [800 Mhz].
If you don't have any DDR2 PC2 5200 memory you might consider getting a 1 GB stick. Newegg.com has got 1 GB of it for around $25.00. [OCz brand].
by dr.llvll Accepted solution
by willcomp Accepted solution
by dr.llvll Accepted solution
by willcomp Accepted solution
PC Chips has a habit of shipping mobos with the CMOS jumper in the Clear instead of Normal position.
I know that you checked this earlier, but wouldn't hurt to double verify that jumper is in Normal position. It will definitely prevent booting.
by dr.llvll Accepted solution
by cg it Accepted solution
by dr.llvll Accepted solution
by dr.llvll Accepted solution
by cg it Accepted solution
I'd return both the motherboard and the processor.
I know PCChips are decent boards though their failure rate is going to be higher than main name brand boards. I had to buy a PCChips board simply because it was the only Socket A boards available at Newegg.com. They weren't rated very high because of failure rates.
If you need an LGA 775 socket for that Pentium 4 processor, try the ASRocks boards as an inexpensive alternative to Asus, Abit ECS,MSI,Gigabyte. [though I have a preference to MSI Gigabyte makes good and inexpensive boards.
Might also consider going to AMD Dual Core Socket AM2 . you can get an AMD dual core for under $100.00 and a decent name brand board board for around $80.00 [Newegg.com of course]
by dr.llvll Accepted solution
I guess I will be just sending it back. I'm sick of the head ache, and I'd rather start back at square one. Anyway, thanks again everybody. You've all been really helpful.
|\/|ark
by cg it Accepted solution
there's that helpful button that gives a thumbs up..
Willcomp needs some of them thumbs up..
by mellow52 Accepted solution
by willcomp Accepted solution
The purpose of a minimal boot configuration is to reduce the possibilities and facilitate troubleshooting (fewer components involved). Swap any other components you can - power supply in particular.
When building a PC, I recommend you assemble basic system on a workbench or table top and test prior to installing in case.
by thumbsup2 Accepted solution
by willcomp Accepted solution
This discussion is closed to new replies.
Trending Hardware posts
Sort by Trending