General discussion

Locked

C# and SCADA

By forum.4321 ·
v r building a remote monitoring system for water purification plant and hop 2 integrate a SCADA system to software written in C#. wht is the best way of doing that?

This conversation is currently closed to new comments.

2 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Communicate

by vanini In reply to C# and SCADA

Use NModbus library for MODBUS support in c#
and the SCADA software has it by default.
Just exchange variables through MODBUS.
www.nmodbus.com

Collapse -

C# and SCADA

by battula32 In reply to C# and SCADA

Hi
First you have to know, what type of hardware (Electronic eqipment) you are unsing to monitor or control that water purification plant. Is that equipemnt( or card) supports software inerface ( I mean is that equipment has serial port or parallel port). What type of communication will taht equipment support. If that equipment support TCP/IP, then you have to write tcp/ip driver to communicate with that equipment and to get and set data.

Regards
Ravi.

Back to Windows Forum
2 total posts (Page 1 of 1)  

Related Discussions

Related Forums