General discussion

Locked

Cannot add Digital Network Port

By thomas_horna ·
I must configure 10 Digital printers on new Print Server NT4.0, but everytime I want to add new port, I receive message "Specified port cannot be added. Parameter is incorrect.". Searching through Microsofts Knowledge Base I found answer that Spooler servise has to be run as System, and be Interactive. But this is case at this server.
It runs as System & Interactive with desktop.
It is SP5 nt4.0 server with up-to-date hotfixes. Spool folder is on separate logical drive. I?ll try to re-set it as default again. But I need to install those printers as soon as possible...
Can someone help?

This conversation is currently closed to new comments.

5 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Cannot add Digital Network Port

by Veetel In reply to Cannot add Digital Networ ...

Try this URL:
http://support.microsoft.com/support/kb/articles/Q179/1/56.ASP

Hope it helps.

Collapse -

Cannot add Digital Network Port

by thomas_horna In reply to Cannot add Digital Networ ...

The question was auto-closed by TechRepublic

Collapse -

Cannot add Digital Network Port

by Cedric King In reply to Cannot add Digital Networ ...

Check out the KB site posted. By right, it should be fixed by Service Pack 3 and if you got SP5 installed, it shouldn't be a problem. You can direct the question directly to Microsoft.

Collapse -

Cannot add Digital Network Port

by thomas_horna In reply to Cannot add Digital Networ ...

The question was auto-closed by TechRepublic

Collapse -

Cannot add Digital Network Port

by thomas_horna In reply to Cannot add Digital Networ ...

This question was auto closed due to inactivity

Back to Windows Forum
5 total posts (Page 1 of 1)  

Related Discussions

Related Forums