Question

Locked

Can't get solo 5300 to recognize 256mg ram chip set

By ron_cronwell ·
I have a solo 5300 with two 128 mg ram chip sets. I have installed XP prof v 2002 with service pack 3. It only has a total of 256 Ram. I am trying to upgrade to two 256 chip sets but it will not boot if I insert them both and will not recognize one if I insert only one. Any suggestions???

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
Thread display: Collapse - | Expand +

All Answers

Collapse -

You most likely have the wrong RAM Modules here

by OH Smeg In reply to Can't get solo 5300 to re ...

As this P3 M'Board can not take more than 2 X 256 MEG RAM Modules they probably need to be Low Density Modules.

You'll need to check with the RAM Maker for the correct Modules for this system.

Col

Back to Windows Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums