I’m having difficulty accessing unit using Console port. Wondering if anyone has any suggestions.
So far i’ve verified console cable is good by hooking it up to aironet 1200 console port and accessing that device with no problems.
Sup Engine info
Supervisor Engine III-NFFC-II
Model: WS:X5530-E3
Using Hyperterm to access devices with the following settings
Com1
Baud: 9600
Data Bits: 8
Parity: None
Stop Bits: 1
Flow Control: None
Emulation: Auto-Detect
Terminal Keys
Input Translation: Shift-JIS
ASCII Setup: only item enabled is Wrap Lines for ASCII Receiving
I have 1 of 2 Pwr supplies enabled which shouldn’t prevent accessing the console. All modules come online according to LED’s and Sup engine displays Active. I’ve tried resetting the sup engine and also tried at various lower baud rates also tried the ctrl-break process to enter RomMon mode with no luck .. i do not get any info coming up on the workstation from the device. Just a blank terminal screen
Any help would be much appreciated
