Discussion Locked

cd rom not working

0 helpful
4 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
just installed a genica 48x ide cd rom. I can't find the drivers for it. Won't show up that I have a cd rom.

4 replies

by thechas

You should only need CD-ROM drivers for DOS mode programs.

At boot, enter the BIOS setup program. (usually Del or F1 key)

Check the settings for the IDE channel that the drive is connected to. make sure that it is set to either Auto detect, or CD-ROM.
Save the settings and exit.

Also, verify that the jumper is set properly on the back of the CD-ROM. (Master / Slave)
And, that the cable is plugged in correctly. (Pin 1 is usually next to the power conector)

The drive should show up on one or more of the post screens.
If the BIOS cannot find it, neither can Windows.

If the drive is connected to a sound card or IDE plug in card, you may need drivers for that card.

by thechas

I have installed 6 of these drives in verious systems with out the need fro drivers for the CD drive.
Some motherboards do need the chipset IDE bussmaster driver installed for Windows to be able to see the CD drive.

You can download a generic cd-rom driver from www.driverguide.com

I also have the DOS driver floppy for the Genica drives, and could e-mial you the files if you need them.

Chas

by mpkrn

Thank you, I got it running. needed a jumper for the ribben for the master connection.

This discussion is closed to new replies.