Discussion Locked

CD RW drive doesn't record to new CDs

0 helpful
9 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have recently had several different brands of CD-RW disks fail to burn right out of the box. One brand of the newer disks even locked up my system when the drive tried to read them.
When I use one of my older CD-RWs, there is no problem with burning or reading.
The new disks all have a black sheen on the recording surface while my old (usable) disks are blue.
Are there different types of CD-RWs and where can I find information on this?
I use a Creative CDRW 4224 burner.

9 replies

by thechas

Are your old disks 650 MB, and your new ones 700MB?

Some of the older drives and software do not support the higher density disks.

You should be able to verify this in the FAQ section at Creatives web site.

I know that Adaptecs older CD software does not support 700MB disks.

by asm

I have buned both 650MB and 700MB. The CD-RWs I have tried were all 650MB

by grbeckmeyer

Also check the recording speed of your new versus the old. Sometimes higher recording speed-CD's will fail on slower burners.

by techkid

you can try upgrading your burner's firmware. However, I think creative drives and support are crap. sell it on ebay and buy a plextor. they're always updating firmware and what not for better performance/funtionality.

by asm

I have upgraded the firmware. It may be that I just need to buy a new drive as new disk technology has made it obsolete

by jaybubbi

all of the above answers are correct.but you also have to consider your pcs capabilities.i run an amd k6/2-350 with 64 mb mem,to burn my cds i have to set the speed in the control panel for the burner to 4x.it wil give me an error if i try to burn any faster.hope this helps.as far as the black sheen,thats probably the manufacturer.
if im telling you wrong on that ,somebody please tell me.

by asm

I am running a Celeron 433 with 348mb. I have tried burning the new CDs at 1x and 2x- both failed. My old CDRWs work just fine at either setting. As for the sheen, some reading I have done indicate it is due to various dyes used in making different brands of CDs.

This discussion is closed to new replies.