Discussion Locked

change display and Monitor

0 helpful
5 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I need to change the display and monitor characteristics within the C:\windows\system.ini file. I have a person with an older Gateway2000 CrystalScan 1024 NI monitor. Customer says" it works, dont want to replace it. Windows 98se is set to a resolution this monitor does not support. How do I get 'Standard VGA 640X480' back in the system.ini? The computer is a used unit he purchased - thought he was getting a deal.

5 replies

by saihib

In system.ini under:
[boot.description]
Make sure this line is present:
display.drv=Standard Display Adapter (VGA)
Why don't you just set the resolution to 640x480 through Control Panel\Display\Settings? Or, in Device Manager you can change the driver for the video card to Standard Display Adapter (VGA) using the Update Device Driver Wizard?

by shanghai sam

Thank you for the display entry, but I still have 3 or more overlapping images. I thought that this may have solved it but it didn't. I'm just going to re-format the drive and start from scratch, there isn't anything on it i can use anyway

by mr miron

Boot up in safe mode you can then set the display properties to what the monitor will handle and then reboot.

by shanghai sam

as I stated, these were networked computers, if I could have booted in safe mode it still wouldn't have made a difference, I had 3 overlapping layers on this monitor and couldn't distinguish which image was what. Thank you for your reply.

by Former member

This question was closed by the author

This discussion is closed to new replies.