I’m currently setting up a wirless lan with a Cisco 4402 Wireless Lan Controller and 3 cisco 1510 Access points. Everything works fine the access points discover each other and I can get from one end to the other. It’s very basic no DHCP servers static IP’s layer2 mode. A couple of thing are bugging about it. 1. Inside the Access Points configuration information in the web GUI it tells me the AP IP Address is disabled which is not possible because if I enter the Command Line Interface it tells me what the IP address is. It also reports it can’t use the static IP address and fails back to DHCP. Everything works so I don’t get what’s happening here. Question 2 the service port on the fron of the 4402 is setup and telnet and SSH session are enabled on it but I can’t access the interface from it. The seesion sends but doesn’t receive. I could really use some specific answers to these questions. Thanks for the help.