Hello
I have a 2600 router that I acquired , and it was booting in Rommon mode …I checked the flash
rommon 1 > dir flash:
File size Checksum File name
12100916 bytes (0xb8a534) 0x79f0 c2600-js-mz.122-23f.bin
and the memory
Main memory size: 32 MB.
Available main memory starts at 0x10000, size 32704KB
IO (packet) memory size: 10 percent of main memory.
NVRAM size: 32KB
So I know the image is there –have changed config registerr to 0x2102 to boot up ‘normally’
Checking the SET command comes this
rommon 3 > set
PS1=rommon ! >
RET_2_RUTC=1045236694
BSI=0
BOOT=flash:c2600-js-mz.122-23f.bin,12;
RET_2_RTS=
RET_2_RCALTS=
?=0
But when I reboot/reset –I get this over and over –it seems to decompress too quickly –I have erased the flash/reinstalled by xmodem and it did not have any errors , and I know the Image works as I have put it on 3 other routers …..any help please folks–or should I just send it back to Cisco :)…..sorry heres the message
rommon 4 > i
System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info
C2600 platform with 32768 Kbytes of main memory
program load complete, entry point: 0x80008000, size: 0xb8a418
Self decompressing the image : #################################################
################################################################################
################################################################################
############# [OK]
System Bootstrap, Version 11.3(2)XA4, RELEASE SOFTWARE (fc1)
Copyright (c) 1999 by cisco Systems, Inc.
TAC:Home:SW:IOS:Specials for info
C2600 platform with 32768 Kbytes of main memory
TIA
