Question

Locked

Cisco controller 4402

By jafspt ·
Does anybody have an "how to" configure a Cisco controller 4402?
Any and i mean any help will be great.
Thanks in advance,

Joaquim
jafspt@gmail.com

This conversation is currently closed to new comments.

1 total post (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Answers

Collapse -

steps

by acedescuatan In reply to Cisco controller 4402

Well, im not entirely sure of the steps but we did start with setting up the interfaces. Both for ap-managment and the management interface. The ip addresses were setup as well as the DHCP and gateway. The controller was then set to layer 2 mode to allow the LWAPs to communicate to each other and to the ap-management interface. As soon as you get the ip addresses of the APs in the WLC save configuration and reboot and set the controller to layer 3 mode. then you can start with creating WLANs.

This is pretty vague but i hope you get the idea. You can find more and maybe a detailed instuction from ciscos website.

Back to Networks Forum
1 total post (Page 1 of 1)  

Related Discussions

Related Forums