General discussion

Locked

Cisco Pix 515 Firewall Config

By c0nv1ct04 ·
I am in desperate need of help. I have followed all kinds of examples on Cisco's site but have been unable to get the Pix to let traffic through. I tried an outbound filter, default and static routes. Does anyone have a working config? I have come to realize that the 515 does not use the same commands as the 550 or 500. Any help is greatly appreciated.

This conversation is currently closed to new comments.

3 total posts (Page 1 of 1)  
| Thread display: Collapse - | Expand +

All Comments

Collapse -

Cisco Pix 515 Firewall Config

by Panther007 In reply to Cisco Pix 515 Firewall Co ...

This is a pretty straight forward and useful link for pix configuration... do forget that you gotta have at least one permit command in the access list and make sure that the access list is applied to the correct interface and that appropriately applied inside or outside...

good luck!!

http://www.cisco.com/warp/public/110/single-net.shtml

Collapse -

Cisco Pix 515 Firewall Config

by c0nv1ct04 In reply to Cisco Pix 515 Firewall Co ...

Poster rated this answer

Collapse -

Cisco Pix 515 Firewall Config

by c0nv1ct04 In reply to Cisco Pix 515 Firewall Co ...

This question was closed by the author

Back to Networks Forum
3 total posts (Page 1 of 1)  

Related Discussions

Related Forums