General discussion

  • Creator
    Topic
  • #2130464

    Cisco PIX Firewall command

    Locked

    by kwoerner ·

    I have to program our Cisco PIX firewall for a couple of situations, and I’m not sure exactly what commands to use. We use NAT inside with a 10.x.x.x network.

    In the first situation, a computer at our school needs to be able to submit and receive files from a Microsoft Sequence Server at the State office on port 1443, or so they tell me.

    In the second situation, I need to setup a public/routable ip address on one of our inside machines so that any outside ip address can communicate with it. I believe I need to use the “conduit permit” command, but I’m not sure on the grammar on either of these questions.

    All help appreciated.

All Comments

  • Author
    Replies
    • #3545458

      Cisco PIX Firewall command

      by beecee ·

      In reply to Cisco PIX Firewall command

      access-list acl_in permit tcp host 10.x.x.x host x.x.x.x eq 1443
      access-group acl-in in interface inside

      and
      static (dmz3,outside) x.x.x.x 10.x.x.x netmask 255.255.255.255
      access-list acl_out permit tcp any host x.x.x.x any
      access-group acl_out in interface outside

      or conduit permit | deny protocol global_ip global_mask [operator port [port]] foreign_ip foreign_mask [operator port [port]]

      • #3547614

        Cisco PIX Firewall command

        by beecee ·

        In reply to Cisco PIX Firewall command

        oops

        access-list acl_in permit tcp host 10.x.x.x host x.x.x.x eq 1443
        access-group acl_in in interface inside

      • #3450364

        Cisco PIX Firewall command

        by kwoerner ·

        In reply to Cisco PIX Firewall command

        Poster rated this answer

    • #3450363

      Cisco PIX Firewall command

      by kwoerner ·

      In reply to Cisco PIX Firewall command

      This question was closed by the author

Viewing 1 reply thread