Discussion Locked

Cloning a Laptop Hard Drive Via PCMCIA

0 helpful
6 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

I have a Compaq Presario with a 6G drive that I would like to upgrade to a 30G drive. I purchased the drive, as well as an external case to mount the drive while I perform a clone of my original drive using Norton Ghost. The case connects to my laptop via PCMCIA slot. (I'm running Win XP)

When I boot using the Norton Ghost diskette, enter the program, and select disk to disk, it does not recognize my new drive. (I have already initialized, partitioned, and formatted the drive) The reason it does not recognize the drive is because the PCMCIA slot never powers up or initializes.

I am confident if I could get the PCMCIA drivers to load using the MS-DOS Norton Ghost diskette, I would have not problems. I'm not positive how to do that (I've tried a few things already to no avail). I'm a novice, and have already tapped several of my more knowledgable friends. Any help would be much appreciated! (I know it is possible as most laptop drive retailers sell data transfer kits that clone via the PCMCIA slot)

Ben

6 replies

by timthetoolman

Hi,

You'll need to make sure that you have DOS drivers for you PCMCIA card on the Ghost floppy.

Then... follow the instructions on this page for what entries to put into what startup file...

http://www.smartdisk.co.uk/support/problem_by_product/pcmcia/pcmcia_problems.htm

(remove spaces from above URL)

Of course your drivers may be named slightly differently. But this will help.

I had a look at the Symanec site looking for specific support for pcmcia devices but found none. Doesn't mean it wont work, just means there's no guarantee...

Cheers,
Tim.

by tsimmo67

There is a possobility that the hard drives have different file formats, which can happen if you are running for example win98 on one hard drive and winxp on the other.

The best way to do it would probably be to set up a little network between the two harddrives, a co-axial cable network would be sufficient. The only problem would be that you would need a NIC card for both machines, but that is definetely the best way to transfer files on a harddrive.

With this option there is also the oppurtunity of sharing files later between the 2 computers or even network games between them:)

Hope that helps
-Travis

by ben

Thanks for your input! Unfortunately I broke down and performed a clean install. I had no glitches or problems! The only real hassel was calling Microsoft to "activate" and register the products I own, and reinstalling all my software.

Conceptually I understand what I need to do to make my PC card work in Dos, but practically I can't get it to work. Your recommended website had good info to help, thank you. I will still pursue this question because I'd like to use Ghost to do a full back up.

Thanks again!
Ben

This discussion is closed to new replies.