Question Locked

Compaq Presario 700z shuts down during re-install

0 helpful
2 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.
I have a compaq presario 700z that has been so bogged down that I decided to reformat and reinstall. The laptop came with a "quick restore" disk set. There are three disks in all. I have the laptop set to boot from the cd drive. The quick restore disks apparently do the reformatting and reinstalling all in one shot. The only problem is that the laptop shuts down in the middle of the process. The battery is very old and wont stay on unless it is plugged in. I can't figure out why the laptop would shut down during the middle of this process even when it is plugged in. Anyone have any idea how I can get this operating system to reinstall?

2 replies

by rob miners

"The battery is very old and wont stay on unless it is plugged in." :)

Presario 700xx And Evo N115 Notebooks May Overheat Or Shut Down

http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?lang=en&cc=us&taskId=110&prodSeriesId=96403&prodTypeId=321957&prodSeriesId=96403&objectID=c01206213

http://bizsupport.austin.hp.com/bc/docs/support/SupportManual/c01124007/c01124007.pdf

Laptops run fast microprocessors that can generate a lot of heat. The heat is mainly vented out of the bottom of the laptop but ventilation effectiveness is reduced when the laptop is placed on a solid surface. A hot laptop can suffer from reliability problems and a system that overheats can fail.
One way to help in this situation is to use a Notebook Cooling Chill Mat, something like this.

http://www.ao3.com.au/product.asp?manufpartno=AWE11US

And if you are feeling adventurous you could try this

If the CPU heatsink is not clogged with dust and lint completely, you can use canned air and just blow it inside the laptop through the openings on the bottom and on the sides. It might not work if your heatsink is completely clogged.

Open the laptop case, so you can access the CPU fan and the heatsink.
Carefully disconnect the fan cables on the system board and remove the fan. If the fan shows resistence when it spins replace the fan.
Clean the fan and the heatsink with compressed air.
I would also recommend removing old thermal grease from the CPU and applying new grease for better heat conductivity. ;)

Let us know how you get on.

This discussion is closed to new replies.