Question Locked

Computer will not start - power light lit for few seconds, nothing happens

0 helpful
3 replies
Closed to new repliesThis discussion is closed. It stays readable, but it takes no new replies.

The computer I just built will not start up. I plugged in all the cables. Once I press the power button, it lights up for about half a second, nothing else boots up, and it all turns off again. Nothing happens.

Here are the specs of my system:
DFI 680i motherboard
4 gigs of Patriot RAM
Intel Quad Extreme CPU
Zalman CPU cooler
18800 GTX Graphics Card
Soundblaster Sound Card
Coolermaster 832 Computer Case
1,000 Watt Thermal Take PCU

3 replies

by leejay.dillon

I would start by going to just the basics that are needed to start a pc: RAM, CPU, Motherboard, try to start the computer with the least amount of RAM and nothing in the expansion slots on the motherboard. If it starts add components one at a time until it won't start again and you should be able to find the component that is causing the pc to not POST. If the computer still won't start with only the basics, then I would suspect one of the basic components as the problem, I would also double check that all of your cables are connected correctly, I once thought I had a purchased three different motherboards that were fried, I returned each of them and on the fourth one realized I wasn't plugging in the correct power connection for the CPU. Hope this helps.

by oh smeg

If not correctly mounted there could be a short to the chassis which is killing the unit and preventing it starting.

Ideally you should dismantle the entire unit lay the M'Board on some White Paper and try powering up there. If it now works look at either the fitting of the M'Board or the Front Panel switches as the problem areas.

Col

This discussion is closed to new replies.